3 Panel White Primer Grain Molded Door
Home » Products » White Primer Door » 8mm Depth Design White Primer Door » 3 Panel White Primer Grain Molded Door
Share to:

3 Panel White Primer Grain Molded Door

Quantity:

Nail the king studs in place. Use 12D nails to nail the king studs in place. Drive the nails at an angle to make a toe-nailed joint, or you can attach the studs with metal connectors.


Nail the jack studs to the king studs. Position the jack studs against the inside of the king studs, and nail them in place.


Insert the header. Take two 2x4s that are cut to a length that equals the width of the original door opening. Use them to make a header that will sit above the door. Once in position, nail these header pieces together to secure. The header should fit between the king studs and sit snugly atop the jack studs.


Insert a cripple stud. Measure and cut one (or two depending on the width of your door) studs to fit between the header and the top plate. This is a cripple stud. Use a toenail to secure the cripple studs to both the header below them and to the plate above them.

WhitePrimer 0

1

2

3

4

5

6

7


Follow Us
Copyrights © 2021 Zhejiang JiHengKang Door Industry Co., Ltd.

CONTACT US

Mob: +86-15669548888
Fax: +86-579-82212898
Email: zjhk@zjjhk.com

QUICK LINK